|Apr 07, 2010, 09:52 PM|
Thrust Vectoring on a Large EDF
FLYFLY Mig-29 Twin 90MM, Roughly 3000 watts.
I have a DX6i, and the GWS elevon mixer I got doesn't work. So here is what I have, video below:
1) Vectoring on/off (elevator only is switchable, rudder always on)
2) Elevator and rudder vectoring, follows elevator.
3) Nozzles fixed at positive pitch, full elevator control (high alpha?)
4) No roll control due to mixing limitations and GWS mixer not working.
I have more up vectoring than down, It was hard to get enough throw going. I figured up would be most benificial. I am trying to fill the gaps between the nozzles and the air frame, but testing shows most of the air is redirected with little seeping through the gaps.
Servos are HS-82MGs. All of the 82MG servos I have have some play, and buzz alot. But they are tough as nails.
Was tough to show them off with one hand holding the camera lol (had to work rudder and elevator with one hand)
WISH ME LUCK!
Going for this but with better music:
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Micro EDF Contest: F-22 Raptor with thrust vectoring for EDF-40 - plans in post #1||Esprit440||Micro EDF Jets and Power Systems||290||Feb 04, 2013 12:57 PM|
|Discussion||Really poor thurst on EDF50||SamurAchzar||Electric Ducted Fan Jet Talk||2||Mar 14, 2010 04:04 PM|
|Video||Micro EDF Contest Entry - F-22 for EDF-40 with thrust vectoring video 2||Esprit440||Electric Plane Talk||8||Mar 02, 2008 10:42 PM|
|Video||Micro EDF Contest Entry - F-22 for EDF-40 with thrust vectoring||Esprit440||Electric Plane Talk||5||Feb 01, 2008 08:16 AM|
|Sold||New F22 Park Jet with Thurst Vectoring Power Combo||Bud Morrison||Aircraft - Electric - Airplanes (FS/W)||7||Dec 11, 2007 10:59 PM|