Round two with 3DHS. I had the 40" Edge about a year ago and I liked it. I was progressing well until I rammed it into the ground.. I'm definitely NOT a 3D guy but I do enjoy the challenge.

I tried to keep it as light as I could. Only one extension and it's 32awg. I soldered the motor's wires directly to the ESC. No shrink wrap on the ESC. Minimal hardware, all bolts and pushrods cut as short as possible, used as few washers as possible, etc. The motor and battery are heavy, everything else should be as light as possible.

AUW: 34oz w/ the 188g 2200mah pack and wheel pants ON
Static test: 340 watts

3D Hobby Shop:
42" AJ Slick

Eflite:
Park 480 1020Kv outrunner
30A Pro ESC

Turnigy:
12x6 light electric wood prop
3s1p 2200mah 40c lipo
3s1p 1300mah 30c lipo

Futaba:
T12FG transmitter
TM-14 2.4Ghz module
R6106HF reciever

Hitech:
(2) HS-56HB servos (ailerons)
(2) HS-65MG servos (rudder, elevator)

Deans:
Ultra plugs