Hi all,

I wonder if someone could help with a question I have about the Walkere CB180?.

I notice there are some threads about this heli, and I wondered how difficult it was to replace the tail rotor blade??.

Many thanks..

Martin.

I've done two already. It's easier to break off the rest of the blades and grab what's left with needle nose pliers and pull off. It's pressed on so you'll have to tug and twist back and forth, but it'll come off. Good luck!

Many thanks indeed, I take it the new blades just press on then??..

I live in the UK and still have a bit of trouble finding replacement parts..

Best wishes,

Martin.

I use wowhobbies.com. Their based out of California USA. Not sure how quick they can get parts too you, but i get them very fast. They only deal with Walkera. Yes they just press on. Do yourself a favor and buy at least 4 you'll need them

Good Luck
Mark

Originally Posted by Martyble

Hi all,

I wonder if someone could help with a question I have about the Walkere CB180?.

I notice there are some threads about this heli, and I wondered how difficult it was to replace the tail rotor blade??.

Many thanks..

Martin.

i just replaced my tail with a new one just two screws to take off heat shield small philipps screw driver flip upside down to remove unfortunately motor still not working properly can anybody give me help with this issue
thanks matt

Can some one explain how to take the tail props off? on walkera cb180D . Do i just pull it right off with my hands or needle nose pliers ? or do i have to screw off something? please and tahnk u , dont want to mess it up more

Originally Posted by seks718

Can some one explain how to take the tail props off? on walkera cb180D . Do i just pull it right off with my hands or needle nose pliers ? or do i have to screw off something? please and tahnk u , dont want to mess it up more

Take an old knife and heat up the tip with a propane torch. Slice down through the old blade to the shaft. The rotor will fall off.

Press the new on on with a small c clamp.

ok
on the walkera cb180d is it normal if it does not have a rudder on or a broken rudder on would it cuse it to spin out about 2 ft off the ground ? and once i replace it with a new one would this problem be fixed?

I got the rudder off , i had to cut it of ,I put a new one on and it hovers the best i love it , lot of fun ! so far so good thank u everybody