Sold the airframe and am downsizing so I have no need for this nice Tru turn 4.5 inch spinner. Diameter and length from backplate to tip are 4.5 inches. I'm including the center retaining bolt. New it cost over 100 dollars so here's your chance to get it for near half price. No damage at all. It's a "p51" spinner but looks great on any giant scale plane. This was mounted on a 100cc Yak 54 and really made it look sharp. The backplate is drilled for a DA/BME/DL/etc. 6 bolt pattern. It might fit more but I know for a fact it fits both my BME 110 and my friends DA 100 prop hub. 60 shipped to the continental US States.

Thanks for looking

Mike

I am very interested, have a p-51 that needs a 4 1/2 spinner. Can you post a pix of the backplate, I will be using it an an electric motor want to make sure it will work.

Originally Posted by mpope1

I am very interested, have a p-51 that needs a 4 1/2 spinner. Can you post a pix of the backplate, I will be using it an an electric motor want to make sure it will work.

I took a pic for you. The center hole is 5/16 diameter from my measurement. I'm sure you can get or have made spacers to neck it down to whatever your motor shaft diameter is.

Mike

I could probably get it to work, I was hoping it was the light backplate. I am a little strapped from X-mas, could you take $50?

Is it sold?

Originally Posted by mpope1

Is it sold?

Yes, it's sold.