|Dec 24, 2009, 10:15 PM|
7.3" Micro Rigger - Extremely fast for its size!
Fun, but its airing out now. Looking for ways to waterproof the hatch...
Sorry for the side ways thing.
|Dec 25, 2009, 07:29 AM|
it took less than half of a 4"x36" sheet og 1/16" balsa. Then it coated in foam safe ca. Main strut from a rtf (i think it came from a dragonfly. A broken vapor gearbox and a plantraco fiberglass 8mm control horn went into the rudder. The hull is less than $5 of bought materials. The motor is $10. The brick is $59 and came out of my Sukhoi. I just hope it is not dead as I let it sit in the water and the transom sunk. Custom drive hardware was $12 plus shipping, but I only used small fractions so maybe $2 worth in the end.
$89 for everything, but if I sold it, I would sell it without the electronics for $50 as it took two weeks to build.
|Dec 25, 2009, 09:58 PM|
There is some building on the page before.
Well I smoked a vapor brick, and my ar6400 is still in the ER. This project is in the boat yard for now, unless someone wants it.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New Product||Silverlit New Micro Acrobat! Its not ir its a rc micro. Now with videos||richos||Micro Ready-to-Fly||75||May 18, 2011 02:52 AM|
|Sold||Celectra 4-Port, 1-Cell, 3.7, 0.3A DC Li-Po Charger, Plus 3 240MAH Single Cell Packs.||jafo216||Aircraft - Electric - Batteries & Chargers (FS/W)||9||Jan 01, 2010 12:55 PM|
|Sold||!!! 7 3.7V 1 Cell lipos for MCX, Ultra Micro Suhkoi, Ultra Micro P-51, ECT. !!!!||801Funk801||Aircraft - Electric - Micro & Indoor Airplanes (FS/W)||4||Dec 21, 2009 06:22 PM|
|Sold||!!! 7 3.7V 1 Cell lipos for MCX, Ultra Micro Suhkoi, Ultra Micro P-51, ECT. !!!!||801Funk801||Aircraft - Electric - Batteries & Chargers (FS/W)||2||Dec 20, 2009 04:39 PM|
|Discussion||Elite1500 Nimh cell the best cell for its size?||haveblue||Batteries and Chargers||0||Sep 04, 2009 09:08 PM|