SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
Reply
Thread Tools
Old Jun 02, 2009, 11:34 AM
Registered User
Boston
Joined Mar 2006
168 Posts
Help!
Yaw does not work

Hello,

I am trying with UAVP 3.15 (original), but yaw command does not work.
(turned off all PID parameters, to see manual commands)

My TX/RX is JR 388S with mode 1, and uses a composite signal.

The symptom is "Receiver" screen shows all commands work fine
(gas, roll, nick, yaw and ch5), and actually roll, nick and gas are working,
except yaw.

Another words, If I move the right stick to right, UAVP moves right, and
if I push the left stck, UAVP moves forward. (mine is mode 1)

However, If I move the left stick to left, nothing happens.

The thing I don't understand is, why "Receive" screen shows OK, while
actual yaw command does not work...

I tried with non-composite signal also, but the result was same
(connected individual ch1, ch3, ch5 and ch7)

Could someone please help me?

Thanks
Eaton
eaton is offline Find More Posts by eaton
Last edited by eaton; Jun 02, 2009 at 01:08 PM.
Reply With Quote
Sign up now
to remove ads between posts
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Say you bought something from a E-zoner and it does not work? LJH Vendor Talk 21 Sep 23, 2003 03:07 PM
FMS (the tx does not work) thor4944 Electric Plane Talk 10 Jun 11, 2003 06:41 AM
Cockpitmaster does not work on new computer? thor4944 Beginner Training Area (Aircraft-Electric) 2 Jun 10, 2003 07:02 PM
New Ezone layout does NOT work for me BEC Site Chat 7 May 23, 2002 12:14 PM