|May 29, 2009, 12:48 PM|
Fasst dropout test with Remzibi OSD
I modified a remzibi osd and a Futaba Fasst receiver to display information on the dropout rate of the receiver. This mod makes the fpv flight more reliable, gives an early warning before loss of control.
This video is the first indoor test of the mod.
The Tx was in range test mode and in critical distance. I lowered the signal by shielding the Rx aerials by hand. The displayed value (the % on the bottom) is proportional to the error rate.
Check the blinking of the green led (good signal) and red led (dropout), the movement of the servo and the corresponding dropout % displayed.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Blitz 400 Flight Test with Wattage Cobalt...||Captain Carlton||Foamies (Kits)||38||Apr 02, 2009 11:27 PM|
|Flight Test with Datalogger||peterangus||Modeling Science||1||Apr 10, 2005 05:54 AM|
|Fighterbird test with the Aerobird X-pack tail||Ed F||Parkflyers||6||Jun 13, 2003 08:25 PM|
|Fighterbird test with the Aerobird X-pack tail||Ed F||Parkflyers||1||Jan 21, 2003 02:41 PM|
|Mugi flight test with bungee!||Vinnya42||Foamies (Kits)||2||Dec 18, 2001 01:29 PM|