|May 19, 2009, 10:10 PM|
Ground set up
This is my simple video RX setup.
Tripod to get that antenna off the ground.
[this did not help, I think the whip antenna needs a ground plane).
Video cables to where I'm sitting.
RV Video Splitter to give vid to goggles and vid camera (recording).
12v Gel Cell Batt to run these.
Patch Antenna (the Goof proof one)
15" DC12v LCD TV (Available from Dick Smith Electronics, Australia) - so others can watch too.
Last edited by RobJCook; Jun 28, 2009 at 02:14 AM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Show us your FPV / RVP ground Base set up in action||Trackercal||FPV Talk||94||Nov 05, 2010 10:21 AM|
|X-250 Set Up||member73||Electric Plane Talk||4||Sep 08, 2001 11:16 PM|
|Wingo Set up||rcdreamer||Beginner Training Area (Aircraft-Electric)||1||Jun 28, 2001 06:56 AM|
|Twin Speed 600 set up||watts goin on||Beginner Training Area (Aircraft-Electric)||1||Jun 10, 2001 02:14 PM|
|set up Astro Flight 4023 esc||die fleidermaus||Beginner Training Area (Aircraft-Electric)||4||May 14, 2001 10:11 PM|