so far i have figered out the other 2 are raptor 30s the one with the fule tank in frount and has a single tail boom brace,can any one tell me what it is im going to put all 3 back in order,is there any newer kits that use the same parts,and are these a 550 size,

The 30 size usually runs 550mm blades. Can use other blades close in size, but not as common. The Raptor 30 shares many of the Raptor 50 parts, as well as many cloned parts (like from the Klone 50). So they should be easy to get parts for.

cool,so like the hobbyking 50 parts would fit, if all posible could i get a list of parts that will mix or a list that wont fit if easer thanks i did hapen to figer out the heli it a jr vencher

Original, and reproduction parts here, for the Raptor.
http://www.helikraft-rchelicopters.c...-v2-parts.html
They also sell the Klone 50. To mix, and match from other helicopters its best to ask about a single part. To many posibilities, some may need other parts to go along with it.
Not sure what a Hobbyking 50 is. They sell an Aeolus, and a JZ. Very different than the Raptors, so entire assemblies would have to be used.

The heli in front in the first photo is a jr venture 30, finding parts for the ventures is getting harder. What engine does it have?

roto thanks for the web site, the jr mite be easy to get going being its ccpm if thats the term alot of clone,and aline parts will fit like complete head and tall parts,im going to start getting parts for them, im no pilot so,they mite not leave the ground for a long time,one thing that im not sure on is the expense worth the bild, i would like to run a 4 stroke on at least one,if you guys have parts that will fit these birds, let me know, thanks

I would think that raptor parts would be alot easier to source, making them the logical choice for restoration, maybe make one out of two?. if you do find other align parts that work on a venture let me know, I have my doubts thow.
Chris.

rite know im having trouble finding a radio i would like a 7 ch fm that later i could go to 2.4 and set of blades,main rotor and shaft and 3 motors, linkages

ok got the radio,know i need parts,anyone have some there willing to trade out let me know thanks

here a update i took apart the motor on the 30 and got it running i took elec tape and taped the blades up all was rusted pretty good little time spent and got all freed up,so yesterday i gave it a try with really bad blades and a prier i gave it a try,for the first time i had a heli lift off and stay in the air lol and i was so happy then the worst thing happened it ran out of fuel, it went down slowly and just stopped i went back to get some more fuel no more in the can if it will fly with blades that have pecis missing and have been crashed then im sure i will have lots of fun, first time hover,i was nerviness i could not think right for 5 min best experience ever with a heli