HobbyKing.com New Products Flash Sale
Thread Tools
Old Dec 10, 2005, 10:26 PM
fffoamy flier
Joined Nov 2004
87 Posts
CNC Question

My project to build this winter is a CNC cutter. I have seen several posts on 4 axis machines to cut wings but is anybody using a simpler 2 axis machine to cut fff/depron parts out. So far I have scraped up a pc power suply, 2 small steppers and ordered the chips for stepper drivers from Jameco. I am getting EDE1200 and using darlington arrays since this seems to be a simple arrangement. I am not sure if any logic will be needed ahead of the driver yet to get it to interface with available software.Building the actual machine seems to be no big deal. Its going to be getting the interface to work right that is scaring me. Any help or suggestions will be appreciated.
j3ned is offline Find More Posts by j3ned
Reply With Quote
Sign up now
to remove ads between posts
Old Dec 11, 2005, 07:39 AM
Evil Plane Doer
jskrebs's Avatar
Westport, Pennsylvania, United States
Joined Dec 2002
1,687 Posts
Have a look @ www.cnczone.com

Also a nice thread om CNC routers in the builders workshop forum on RCG
jskrebs is offline Find More Posts by jskrebs
Reply With Quote

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
CNC Question pitoniakmike Hand Launch 3 May 31, 2005 09:27 PM