|Dec 23, 2011, 08:48 AM|
Israel, Ness Ziona
Joined Sep 2004
AP -First flight .New quad -FH-X46 Pro (TMF PRO)
SO...First test flight with my new quad copter...FH-X46 Pro (TMF PRO)
I took it today noon time to Ramat Gan in a local park were a big Bike race was held..
The good things with the board:
After it is ACCel armed ..And trimmed it flyes GREAT and steady as a ROCK...
The BAD things i have found :
Arming the ACCEL can be
As few times i did that Slow and easy it did not work properly..as LED did not Flash as needed.
Disconnecting the lipo power and starting all over...
The board RX Trimming Change in air an=re not to bad ..still need to check..
So the write thing to do is to take off 3 feet up just before your flight..
After arming the ACEL and triming all.
Land down..and disarm motors- WITHOUT disconnecting the lipo!
This is CRITICAL when you need to take off in exact time - pin point ( bike race asart or 1000 runners on start line)
Or just AP these critical events with my Gaui quad that is OK and i can just Plug..Full power-- and up
And do "Calm" ap \ av with the FH-X46 Pro..
I will see that as i go on testing...
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion FH-X46 new quadcopter and hexacopter controller from FOXTECH||glassfox||Multirotor Talk||730||Apr 30, 2012 08:14 AM|
|Discussion Need help! - FH-X46 Pro and RD800 TX||guyg||Multirotor Talk||3||Dec 22, 2011 02:00 AM|
|Discussion Need help! - FH-X46 Pro and RD800 TX||guyg||Aerial Photography||1||Dec 20, 2011 03:51 PM|
|Discussion FH-X46 Pro \ AQ50 Config-setup help||guyg||Aerial Photography||1||Dec 18, 2011 03:18 PM|
|Sold TMF FC aka fh-46x flight control board||Quad_Addict||Aircraft - Electric - Multirotor (FS/W)||1||Jun 19, 2011 09:37 PM|