|Dec 10, 2013, 08:47 AM|
Eagle Eyes Connection issue, Can't update, no In1, no LEDs
I wonder if anyone could shed some light on an issue that I'm having with my Eagleyes.
This is a brand new EE, firmware version 1.18.
Firstly I can't update the firmware, every time I get the same error (''FDRV2 Application - A firmware programming error occurred''), even with 12v supplied to the power connector.
Tried connecting usb then power barrel, and vice versa.
Tried different usb cables. Tried on a different computer, in all usb ports.
I also have no input on 'In1' on the board. 'In2' works fine and all the 'outs' work fine too.
I also have no led's lit on the board or buzz from the speaker.
Am I doing something wrong? Herd of anything similar?
|Dec 10, 2013, 08:59 AM|
You can cycle through the available modes (AV in 1, AV in 2, Diversity and Telemetry) with the small "select" button on the unit. There are LEDs that will light up depending on the mode selected.
Can you be sure you have our latest software version installed? If you are unable to update the firmware, please open a support ticket on our website and we will help you get it sorted.
|Dec 10, 2013, 09:12 AM|
Thank you for your quick reply.
I'm using ET application v10.52.
I'm trying to update the EE to firmware v1.26.
I've tried selecting to different modes with no result. I don't have any LED's lit on the board. I have tried this on 8v and 12v power into the barrel connector.
Should I get any audible 'beeps' from the speaker?
|Dec 10, 2013, 09:29 AM|
If you are unable to make and selections with the button or update the firmware, we probably need to have the unit sent it to check out. Please open a support ticket on our website and we will help you get it sorted.
|Dec 10, 2013, 09:46 AM|
Thanks for your advice, I have open uped a ticket on the ET support page.
Just my luck! Just got the plane all built up and ready. This was the last piece to the setup
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Can't connect to rchomepage||Martin SJ||Site Suggestions / Complaints||1||Dec 09, 2013 09:42 AM|
|Discussion||Can't get connection to the tilt function, Zenmuse||seamp||FPV Talk||0||Dec 06, 2013 02:31 PM|
|Mini-HowTo||Eagle eyes (EE) ground station unit connection problem||churel||Eagle Tree Systems||1||Dec 02, 2013 08:58 AM|
|Sold||Eagle Tree Eagle Eyes - Case||fpvbasher||FPV Equipment (FS/W)||3||Nov 23, 2013 05:36 PM|
|Help!||No Servo movement with Eagle Eyes Connected||Michael64||FPV Talk||3||Jul 03, 2010 11:02 AM|