|Oct 29, 2013, 08:35 AM|
Bradford West Yorkshire, UK
Joined Apr 2010
Mark length with a felt tipped pen, file around glass with corner of a triangular file, apply a drop of spit to the line and break using fingers. Clean and rotate ends in a blowlamp flame to fuse end of glass.
|Oct 29, 2013, 08:37 AM|
United States, MA, Mid-Cambridge
Joined Apr 2008
|Oct 30, 2013, 08:47 AM|
I don't file all around the glass, but put just a single mark on "one side". The filed mark should be facing away from you as you pull back on each side of the mark. That is, the filed mark should be under tension as you snap the glass.
You can wrap the glass on each side of the line with 2 pieces of paper to protect your fingers from glass splinters, in case the glass tubing has an unseen flaw and shatters instead of snapping cleanly.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||How do you cut balsa wood?||austinlam123321||Balsa Builders||44||Nov 19, 2013 08:28 AM|
|Discussion||Do I know how to build a wing or do I know how to build a wing?||gva1956||Sailplane Talk||14||Jul 02, 2013 09:36 AM|
|Sold||texan glass fuse 40.00 Fuse length 39inch||bendix1||Aircraft - Fuel - Airplanes (FS/W)||0||Mar 04, 2013 06:47 PM|
|Discussion||How Do You Throttle Calibrate an ESC with Red Wire Cut||daskim||Multirotor Electronics||1||Jan 14, 2013 01:05 PM|
|Discussion||How do you successfully fold longer lengths of Blucore and why?||airdawg||Foamies (Scratchbuilt)||14||Aug 19, 2006 11:25 AM|