Bought one yesterday as it was discounted and that they're not produced anymore.
I'm not new to the hobby but I'm having a tough time calibrating throttle range. The 6410NBL manual states starting up at full throttle, wait for the RX/TX be linked, go back to half throttle and wait ten seconds.
It just doesn't seem to go into programming mode.Also trimming down fully and re-bind makes the linearity even worse (about 10% throttle until motor starts).
Any suggestions? This thread mentioned this issue on page 24 but no final solution reported - or other people having this issue for that matter.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Official Eflite UMX Beast Owners thread!||darksiede||Micro Ready-to-Fly||19066||Today 07:34 AM|
|Discussion||E-flite UMX MiG 15 DF SNEAK PEEK!||D PAYNE||Micro EDF Jets and Power Systems||2291||May 07, 2015 06:50 PM|
|Discussion||UMX Mig-15 DF Mod Thread||NitroCharged||Micro EDF Jets and Power Systems||1141||Apr 02, 2015 04:42 PM|
|Discussion||Hobbyking Lancaster official owners thread||Tartago||Electric Warbirds||979||Aug 10, 2014 11:58 AM|
|Sold||Eflite F-86 Sabre 15 DF NIB!||blue7.62||Aircraft - Electric - Jets (FS/W)||1||Apr 05, 2012 01:35 PM|