|Jan 06, 2013, 03:58 AM|
United States, NC, Indian Trail
Joined Dec 2012
Reciever Question Futaba 2006 s-fhss 2.4 ghz
I built this plane and want to make sure that i have everything correct, but the instructions are unclear about the receiver antenna. its a futaba 2006 s-fhss 2.4 ghz. it has 2 wires coming out of it. my question is this, do i need to extend the receiver wires? or are the wires that are original long enough? i did a distance check with rx-tm and it passed the test, but would like some input just to make sure.
|Jan 06, 2013, 12:19 PM|
Joined Jan 2007
Do not modify the wires! They are just as intended. They should be mounted so they are at about a 90 degree angle to each other as the instructions state.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Off Site||Like new Futaba 8JH 2.4 GHz TX and RX S-FHSS/FHSS||crosby||Aircraft - General - Radio Equipment (FS/W)||4||Jul 07, 2012 04:53 PM|
|Sold||Futaba 6EX-2.4 GHZ radio and reciever||Beaver1||Aircraft - General - Radio Equipment (FS/W)||0||Jun 13, 2012 08:06 PM|
|Sold||Futaba 6J 2.4 2.4GHz S-FHSS||kaging||Aircraft - General - Radio Equipment (FS/W)||2||May 31, 2012 05:45 PM|
|Sold||Futaba 6j-2.4 s-fhss||flynut67||Aircraft - General - Radio Equipment (FS/W)||0||May 18, 2012 08:21 PM|
|Wanted||Spektrum Dx5e or Futaba 4YF 2.4 GHz FHSS||Cmarch||Aircraft - General - Radio Equipment (FS/W)||1||Jun 15, 2010 11:29 AM|