 |
 |
 |
|
Oct 02, 2012, 12:11 PM
|
|
Long Valley, NJ, USA
Joined Dec 2001
1,464 Posts
|
Advice on working with XDP
I needed to run the XDP program to change the channel mapping on some nano receivers. I had a perceived problem where I thought the XDP program could not see the XDP device.
I have Windows 7. Installed the latest program from XPS (as Administrator) and the drivers installed successfully. Even tried a new usb cable. Turns out the XDP program was looking for the actual receiver - not the XDP device! It works just fine. I felt a little foolish, but was relieved to be able to make progress on the project. Paul |
|
Last edited by FlyingW; Oct 03, 2012 at 07:54 AM.
Reason: continuing education
|
|
|
|
Oct 02, 2012, 02:31 PM
|
|
|
Long Valley, NJ, USA
Joined Dec 2001
1,464 Posts
|
Got it working as described above.
|
|
|
Last edited by FlyingW; Oct 03, 2012 at 07:54 AM.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion Help. Cannot get started with Flamewheel and DJI | alan2 | Multirotor Electronics | 8 | Sep 05, 2012 06:52 PM |
| Discussion APM2.0 AUTO RETURN HOME SUCCESS! But cannot get position hold. OPEN MY PIDs. | votreami | Multirotor Talk | 2 | Jun 08, 2012 06:04 AM |
| Help! Cannot get gyro to hold the tail | radarman | Large Electric Helis | 0 | May 05, 2012 02:37 PM |
| Discussion Cannot get 12v DC output from Delta DPS-700EB | brightfan | Batteries and Chargers | 5 | Apr 01, 2012 12:06 AM |
| Sold xtremelink device programmer (xdp) | 4*60 | Aircraft - General - Radio Equipment (FS/W) | 2 | Apr 18, 2010 02:01 PM |
|
|