|Dec 09, 2012, 06:17 AM|
Joined May 2007
PPM SUM with V10.53 Firmware
For using PPM SUM, I flashed Latest Firmware to OSD & E-logger with V10.53 Firmware.
After using PPM SUM, The AMP & RSI indicate wrong value.
|Dec 12, 2012, 02:47 PM|
Hi, I think you may need to do a "factory reset" after the upgrade to that version. We've had a couple of other reports of this. To do this, you'll need to click the "Factory Reset" button on the OSD PC Setup screen, and then set up your OSD again.
I would recommend saving your OSD configuration file before doing this, and then do the reset and set up the amp and RSSI parameters to make sure they work. Then, if they work, try loading the saved OSD configuration file, and see if things still work correctly. If they do, you will be able to avoid reconfiguring all your OSD settings.
Sorry for the trouble - let me know if that does not correct it.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||PPM-SUM output from Multiplex M-LINK recievers?||berthrsd||Multirotor Electronics||1||Feb 03, 2013 04:18 PM|
|Question||what is the pulse width of a ppm sum pulse?||doughboy||Multirotor Talk||7||Nov 04, 2012 03:55 AM|
|Discussion||Any way to get PPM Sum from a Turnigy 9x receiver?||signal15||Radios||3||Jul 17, 2012 01:42 AM|
|Help!||ASSAN 2.4 SUM PPM and muiltiwii(quadrino)||shultz||Multirotor Talk||3||Jun 10, 2012 01:27 PM|