|Jul 20, 2004, 03:19 AM|
Pro Peak Prodigy and SJ Swallow chargers -Calibration screens
Not sure if anyone cares about things like this, but if anyone likes to fiddle I have stumbled on the calibration screens in my SJ Swallow (AKA Ripmax Prodigy).
Hold down the two outside buttons (Batt Type & Enter/Start/Stop keys) before you power up the charger. Keep holding for about 3 seconds and the cal screens come up.
BEFORE YOU DO ANYTHING. Toggle through the cal screens and write down the current cal numbers so you can back track to original state.
So far I found I could trim the Input voltage reading, and the Discharge current settings. Input Volts was out a bit, current was VERY close to spot on anyway so I left it. I'd like to cal the Battery Voltage too but I'm buggered if I can figure that screen out, it seems to grab a battery voltage value (in A/D steps) as you enter the screen but will not adjust. I can't work out the Charge current calibration either but my unit is spot on anyway.
New cal values seem to store automatically when you get the 'finished' message.
If any other manic fiddlers out there find the answer to the last two adjustments please let me know.
PS> You need to know a little about whay your doing with this sort of thing or you'll end up burning your house down next time you charge a battery..... BE WARNED.
PSS> My Swallow works well as is and has been very good value for money, I'm just curious by nature.
|Jul 23, 2004, 03:13 PM|
Joined Nov 2003
Yes, very great tool for just a little money. I've just finished cycling my packs.
So - writing in simple to understand language - what things can we change in calibration mode?
|Jul 23, 2004, 07:42 PM|
Cool, i have 2 of these chargers!, i will go try it now, one of my charges is about 200mah to low on the mah taken during charge display, also when set to 1200mah charge rate one of my prodigy's is actually charging at 1.7mah!! maybe i can adjust this as its been bugging the hell outta me for a while now.
The charts below i took whilst charging see the proof there!.
|Jul 24, 2004, 04:59 AM|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Another new Lipo charger - Pro-Peak Prodigy||wildpalms||Batteries and Chargers||159||Sep 17, 2005 04:57 PM|
|Pro Peak Prodigy||Cha0sEngine||Batteries and Chargers||3||Jul 07, 2004 02:47 AM|
|13.8V input to a pro peak prodigy ( UK )||tramsden||Batteries and Chargers||1||Jun 09, 2004 11:31 AM|
|Pro-peak Prodigy - settings?||Andyfree||Batteries and Chargers||2||Apr 26, 2004 04:24 AM|
|Question 12v power supply for pro-peak prodigy (uk)||mjh9335||Batteries and Chargers||7||Mar 25, 2004 05:54 PM|