Originally Posted by JimDrew

You can also specify the failsafe type of each channel.

Will failsafe be triggered by lack of input, when PPM is used?

Fred

Originally Posted by TTRotary

OK. Maybe I'm not understanding, but I was hoping for an Rx that automatically gives you Rx pack voltage on the radio's display as the Optima / A9 does, without using up another channel. Perhaps this feature can be adressed with the Divbee Nano / RF V2?

In any case, I like this modular idea and I am happy to hear the FCC would not be involved. These AMA expo samples...would they be take-home-to-test samples?

No, they may not even be functional samples if they don't get back to me in time.

Originally Posted by flarssen

Will failsafe be triggered by lack of input, when PPM is used?

Fred

Yes.

When will the 10 channel expander and the connecting wire to the Nano receiver be available?

No release date, but I am showing prototypes at the AMA expo this weekend.

Any updates for us Jim?

Just received the production DivBee modules for R/C today.

Originally Posted by JimDrew

Just received the production DivBee modules for R/C today.

sweet!

Originally Posted by JimDrew

Just received the production DivBee modules for R/C today.

A little concerned about that snap-on coax connection. It's fine inside the radio / TX module where it doesn't move around, but could be troublesome inside a fuse? I assume these are the RF modules we're looking at?

Are the 10ch boards in yet?

Originally Posted by JimDrew

Just received the production DivBee modules for R/C today.

looks nice, i suppose you will supply antennas of various lengths?
a question; what happens if the two connectors are rotated so that they touch.
(accidently, of course)

Originally Posted by TTRotary

A little concerned about that snap-on coax connection. It's fine inside the radio / TX module where it doesn't move around, but could be troublesome inside a fuse? I assume these are the RF modules we're looking at?

Are the 10ch boards in yet?

The RF unit will be inside of the case with the snap-on u.FL connectors glued. All you will see is two coax wires.

10 channel boards and RF unit boards won't be available until March.

Originally Posted by E_ferret

looks nice, i suppose you will supply antennas of various lengths?
a question; what happens if the two connectors are rotated so that they touch.
(accidently, of course)

No, there is only one length, which is a tuned coax (yes, it does matter). That length is 230mm with a 28mm strip. The connectors won't rotate, but if they did, they are both ground so nothing would happen.

Originally Posted by JimDrew

The RF unit will be inside of the case with the snap-on u.FL connectors glued. All you will see is two coax wires.

10 channel boards and RF unit boards won't be available until March.

Does this mean we can purchase these at "Toledo"?....

Originally Posted by JimDrew

The RF unit will be inside of the case with the snap-on u.FL connectors glued. All you will see is two coax wires.

10 channel boards and RF unit boards won't be available until March.

Thanks for both responses Jim. I'm going to allow myself a little "woohoo!" on that date.

Given this expander and RF unit, are you still contemplating that integrated 9-channel with telem or is that over with now.

Out fo curiousity - why are the antennae longer for these than the nanos. I suspect this is a simple question with a complex answer...

Originally Posted by tande

Does this mean we can purchase these at "Toledo"?....

Yes. I will be bringing them to Toledo.