|Jan 26, 2013, 12:08 PM|
OSD video bouncing. Why? Please help.
Video coming from OSD starts to flicker/bounce just after Eagle Tree Systems boot.
Why does this happen?
See the video below.
|Jan 26, 2013, 06:10 PM|
Hi, there are a couple of things that can cause that.
Could you please try the following:
1) try turning off telemetry. That is on the "Eagle Eyes" on-screen setup menu in the OSD, which can either be accessed via the radio sticks or the PC software.
2) Try turning down the white level, and/or increasing the black level. Those settings are in the "Display Settings" menu.
Let me know whether one of these resolves it, and we'll figure out next steps.
|Feb 18, 2013, 06:48 PM|
Does your video in or out port have the ground pin connected? Something similar happened to me when I disconnected the black wire. Doesn't look exactly like yours though, only the text was bouncing, not the entire video.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Complete starter Fpv system. Plane/Osd/Goggles/Video/Spektrum||Johnnymeg||FPV Equipment (FS/W)||8||Mar 12, 2013 12:24 AM|
|For Sale||Range Video OSD gen 5||jebzdzidy||FPV Equipment (FS/W)||1||Feb 19, 2013 05:18 PM|
|Help!||Bouncing Text on OSD||KentF||Eagle Tree Systems||3||Nov 20, 2012 10:21 PM|
|Help!||Video will not transmit pleas help||tonywayne||FPV Talk||7||May 19, 2011 03:00 AM|
|Discussion||Gaui EP100 bounces a bit? Video included. Can anyone help please?||turnbui||Micro Helis||7||Aug 26, 2008 01:30 PM|