|Jul 08, 2005, 05:26 PM|
Have question:Need Advice
What would be the best receiver battery for this setup using Futaba Flight Pack with an R127DF Receiver and 4 S3004 Servos?
|Jul 08, 2005, 06:54 PM|
..if you were paraniod, you could do like I have and use a 6V (5 cell) 1800mAh pack..
Servos will draw about 20-30% more power from a 6V pack than a 4.8V pack, so in order to get the same flight time from a 6V pack, youll need to get a higer capacity than the 4.8V pack.
The 4.8V 600mAh pack is the standard, and with 4 s3004 servos, you should get better than 50 minutes flight time before the batteries get questionable. But as is good practice, check your bats before each flight, and if in doubt at all.. charge 'em.
A charge is a cheap insurance against losing your plane due to dead batteries.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Tekoa Core Cutting Question--need advice||theclaw||Sailplane Talk||3||Mar 30, 2007 01:07 AM|
|Question Have a Ditto Tape drive motor and need advice||ProudTexan||Electric Motor Design and Construction||20||Oct 19, 2006 01:37 PM|
|Question Aveox question (need advice)||kyredden||Power Systems||1||Dec 10, 2005 12:27 AM|
|Need advice so I only have to do it once.||stickflyer||Aerial Photography||14||Jun 11, 2005 10:46 AM|
|Formosa Brushless Power question-need advice!||mrebman||Parkflyers||24||Apr 22, 2004 11:37 PM|