Originally Posted by oleost
Thanks, tried fixing all the issues mention here. But still no go.
The gyro itself works, if I connect it to the PC with cable I can adjust the vstabi settting, also if I move the gyro it moves the servos so its active.
I just cant get it to bind to the rx part.
Anyone sees another spot? And if not I will try and put it in the oven as I dont have a reflow station only soldering iron. Anyone guessing what the plastic connectors can withstand of heat? Or should I desolder them before trying to oven reflow?
I would not relow the whole board, just touch-up the questionable solder joint with a small iron and a little flux.
The processor solder joint "look" OK, but who knows. Make sure oscillators are working, an oscope will help, but first make sure those two voltage regulators are working.
Clean the board after rework with a little acetone on a short bristle brush and some tissue paper.
It is hard to troubleshoot small boards and not having all the right equipment.