|Aug 21, 2014, 08:35 AM|
Joined Aug 2014
Some motors louder after bearing replament
I have a quadcopter with those motors and 10x4.7 props. Recently after a crash all the motors produced a grinding sound when turning. I took the quad to a local hobby shop and bought replacement bearings.
I've also asked them to replace the bearings in one of the motors, and I decided to replace to rest myself.After replacing the bearings the grinding sound is gone in all motors. However the ones I replaced are slightly louder than the ones the store staff replaced
How much of a concern is this?
|Aug 24, 2014, 09:51 PM|
And on the noisy one, if you can run it slowly and press on the end of the shaft, first from the top and then from the back or circlip end, if the noise goes away that will usually let you tell if you have a damaged race or balls.
Like Mortimer said, all the pushing forces to seat the bearing have to go on the outer race, never on the inner race. In most cases laying a flat washer on the bearing to press it in will do it without putting any pressure on the inner race.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||louder motor sound with brushless motors||hali||Power Systems||4||May 18, 2014 09:14 PM|
|Discussion||After some advice on choosing my next Glider||toneee||Sailplane Talk||3||Apr 16, 2014 12:53 PM|
|Discussion||After some help please.||M4TT||The Builders Workshop||6||Oct 29, 2013 05:19 PM|
|Discussion||Cant Find Replament 6MM Prop Adapter for Foxtech Motors||akfreak||Power Systems||0||Oct 10, 2013 02:17 PM|
|Discussion||Hoping for some OK-Infinite motor bearing crossover info||CNY_Dave||Power Systems||18||Feb 07, 2012 04:59 PM|