|May 05, 2014, 03:24 PM|
Canada, BC, Capital
Joined Jan 2014
I am new this.
Can I use a 12volt power supply like the one for your Vrx? (The small block you plug in the wall and then your 12volt device. It says 12v 500mA output)
I was hoping I could use one for testing and set up while I wait for my batteries. With the appropriate connectors of course.
Same question for a BEC would a 5volt one work?
I am also waiting for props, so safe time to config the KK2 and ESC's.
Thanks for any input.
|May 05, 2014, 03:51 PM|
No and probably No, (not quite sure on your use regarding powering the BEC).
I would not recommend using a wall power unit to power an ESC, or anything else radio related, (except for maybe charging the transmitter battery, depending on the voltage and charging current).
Wait for the flight batteries, (and I hope you have a Lipo charger and suitable power supply).
The receiver can be powered by a 4.8v to 6v pack if you want to set-up servos etc.
Do not use a 4.8v/6v and the BEC at the same time, one or the other.
|May 07, 2014, 04:51 PM|
The previous responders gave good answers to your initial questions.
Since you are new may I suggest you read this:
Good information there about the care and feeding of your batteries.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Review||Horizon Hobby and E-Flite Carbon-Z Cub BNF Basic||Michael Heer||Scale ARF/RTF||9||Dec 31, 2014 10:42 AM|
|Discussion||Hillary Clinton Cancels Appearance Where Benghazi Victim's Mom, Protesters Await||Yort69||Life, The Universe, and Politics||41||Apr 14, 2014 10:30 AM|
|News||Opportunity Awaits at Horizon Hobby||Jim T. Graham||Electric Plane Talk||61||Mar 03, 2014 04:58 PM|
|"...like Dr. Frankenstein awaiting a lightening bolt"||Barto||Electric Plane Talk||1||Jun 16, 2001 02:56 AM|
|Pic of Terry Awaiting First Flight||BH||Foamies (Kits)||15||May 04, 2001 01:25 AM|