Hi guys,since a lot of your builds involve nacelles this seems like a good place to ask.
I'm looking for a fan,preferably with an intake lip that I can use as a basis for a 70mm nacelle.Unfortunately few suppliers list this dimension and those I've emailed haven't replied.
Like all of us I'm looking for the best fan at the best price,something reasonably efficient and reliable without breaking the bank.Wemo do a 64mm that looks promising,but again no outer lip dimension.
Any advice/ideas/nudges in the right direction will be greatly appreciated.
Regards Stuart.

Originally Posted by Stupot46

Hi guys,since a lot of your builds involve nacelles this seems like a good place to ask.
I'm looking for a fan,preferably with an intake lip that I can use as a basis for a 70mm nacelle.Unfortunately few suppliers list this dimension and those I've emailed haven't replied.
Like all of us I'm looking for the best fan at the best price,something reasonably efficient and reliable without breaking the bank.Wemo do a 64mm that looks promising,but again no outer lip dimension.
Any advice/ideas/nudges in the right direction will be greatly appreciated.
Regards Stuart.

Hi Stuart. . . I know for a fact that Change-sun 70mm fan & HET fan units come with a removable intake inlet shrould.

Try HK and Ejf dot com for their edf units.

Originally Posted by demondriver

Hi Stuart. . . I know for a fact that Change-sun 70mm fan & HET fan units come with a removable intake inlet shrould.

Try HK and Ejf dot com for their edf units.

Thanks DD.Same story I'm afraid.At70mm the CS is too big,no outer lip dia on any of the others.Looks as though I'll have to stick a pin in my list of possible 64mms and hope I get somewhere near.
Regards Stuart

Originally Posted by Stupot46

Thanks DD.Same story I'm afraid.At70mm the CS is too big,no outer lip dia on any of the others.Looks as though I'll have to stick a pin in my list of possible 64mms and hope I get somewhere near.
Regards Stuart

Don't forget Stuart you can take any 64mm edf and make your own intake shroud out of balsa or foam.

Originally Posted by demondriver

Don't forget Stuart you can take any 64mm edf and make your own intake shroud out of balsa or foam.

Just being lazy!
Regards Stuart