|Oct 12, 2002, 09:30 AM|
DC Hobby's Allure -- Good conversion candidate?
Good balsa 2 meter ship kits with ailerons are hard to find. I was eyeing this kit as an electric conversion with a light direct drive brushless motor and 8 1300 CPS. Any thoughts?
|Oct 13, 2002, 12:13 AM|
Wilkes-Barre/Scranton, Pennsylvania, United States
Joined Nov 2000
After doing several conversions I have learned to check the following:
Make certain the motor you intend to use will fit in the nose of the plane. It is a lot easier to make adjustments now than after the fuse is built.
Same for the battery. Will all the equipment fit in the space available. You will be adding a battery pack,an ESC and a motor. These are items that were not in the original design and so they must be compensated for. Place these items carefully. It will make balancing easier later on.
if using ailerons use a servo in each wing. Two reasons for this-more positive control due to shorter linkages and it allows the wing center section to be free of the aileron servo. You will most likely need all the room you can get in that area.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||E-Hobby RC Brushless motors and ESC's any good?||TheDustyPagan||Power Systems||7||Apr 04, 2007 12:10 AM|
|Discussion||Hobby Lobby's Glow to Electric conversion "Helper Service"||JAM||Glow to Electric Conversions||14||Apr 05, 2006 05:10 PM|
|cp1700's looking good!||p471701||Electric Ducted Fan Jet Talk||4||Jul 27, 2001 12:52 PM|
|Watt Age esc's, No good? Or just mine?||slowflyer||Electric Plane Talk||9||May 29, 2001 09:38 PM|
|EDF's From Germany & Conversion Rates||AndrewK||Electric Ducted Fan Jet Talk||23||May 22, 2001 02:31 PM|