|Oct 14, 2012, 03:44 PM|
United Kingdom, London
Joined Oct 2012
JR Receiver with Graupner Brushless Control 18
I just started my RC hobby and have currently some issues with getting my Graupner Rookie to work with my transceiver and receiver.
I bought the pre-built Graupner Rookie, which already has the servos and the electric motor installed.
I separately bought on Ebay:
- JR NER-549x receiver 35mhz
- JR X-3810 transceiver 35mhz on PPM mode
However when i connect the two Graupner servos and the Graupner Brushless control 18 to the receiver, the brushless control keeps giving a blink red light, indicating an error. It also does not make the DO RE sound it should make. I must say that the two servos are easy to plug into the receiver, but the brushless control connection goes a little difficult into the receiver.
At some point when I had my controller on ZPCM the servos started to move like crazy in all directions, but I assume it should be on PPM?
Is the Receiver not compatible with the Graupner Brushless control?
Any guidance would be much appreciated!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Graupner smc 19 pcm receiver with Futaba FX 18 transmitter||crapula||Radios||0||Jun 10, 2009 12:40 PM|
|Wattage Live Wire, Hacker B20-22s, Jeti 18 brushless controller, receiver, servos||DrDHalko||Aircraft - Electric - Airplanes (FS/W)||7||Nov 08, 2003 12:54 PM|
|WTB: 4 HS-55 Servo (JR) - Mini AC 1215/16 - Jeti 18-3p brushless controller||Fiasco||Aircraft - Electric - Airplanes (FS/W)||7||Jun 06, 2003 03:44 AM|
|Mega brushless 45/3 with Graupner sensorless controller||14thflyer||Aircraft - Electric - Airplanes (FS/W)||1||Mar 01, 2002 07:53 AM|