|Aug 17, 2012, 02:51 PM|
Joined Aug 2012
Skid steering robot- need help with RC mixer choice
Hello! I am part of a university robotics team, and I was wondering if you could help me some with a specific issue:
We have 3 RC robots that are skid steering, 2 wheels per side. We currently are mixing the channels on the radio controllers themselves, but this has some issues, such as being very very finicky, and we cannot seem to get full speed forward and back- when turning the wheels spin faster than they do while driving normally..
The robot speed controllers are RoboteQ controllers, and each is at least 60 pounds. However, they just use standard radio receivers, so the size shouldn't matter.
I was wondering if there is a way to use a hardware mixer on the robot itself to control this, making the radio setup simpler. Ideally the mixer would be programmable, allowing potentially different motor speeds to be corrected and allowing it to drive in straight lines easier.
Does anything like this exist? I see people saying that v-tail mixers can do this.. but they do not seem to be programmable.
|Aug 18, 2012, 04:45 AM|
Joined May 2012
If you are using an Arduino, you can use my example project for calibrating and mapping from a stick or wheel type transmitter to two independently driven axles - my example is track driven, but the same concept applies to skid steers.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Newbie Needs Help with RC Sailboat Decision||UncleGuy||Sailboats||16||Jul 08, 2012 11:46 AM|
|Discussion Need help with a plane choice||RCAddict16||3D Foamies||5||Jun 02, 2012 01:11 PM|
|Discussion 180 ° steering XQ-RS313E robotic servo||cathy_yin||Robotics||0||Feb 22, 2012 10:17 PM|
|Discussion Help with thrust steering mixer||lupy||Scale Boats||14||Nov 18, 2007 11:54 AM|
|Discussion Need help with first RC Truck Choice||TerryE||Electric Power Cars||8||Apr 24, 2006 07:08 PM|