|Mar 27, 2012, 09:50 PM|
Burnt-out throttle channel in Optima-6 receiver
I have an Omega 1.8M electric sailplane. It has about about 65 flights on it with an Optima 6 receiver. No problems at all, but I put in a new motor - Hyperion 2213-14 - and it wouldn't run - just shake. The servos still moved. I replaced the speed control - same behavior.
Then the receiver stopped coming on. I then jiggled the wire from the ESC to Ch3 and the receiver would flash on and off. And yes, the connector was fully inserted into the slot.
I then tested the same ESC and motor with a new Optima 6 receiver - binding to the same model memory in my Aurora - and everything works fine.
My conclusion is that the throttle/BEC channel in the other receiver burned-out or for some other reason malfunctioned.
Does that sound right? Is this common? Is there something that could have caused this such as using a servo extension between the ESC and the receiver?
|Mar 27, 2012, 11:35 PM|
Joined Aug 2002
not all plugs on ESC have the same internal dimensions
After Market Accessories - Leads, Modules & Switches - Cautions. - refer to picture attached
Please refer direct to:
Hitec Warranty & Service
Note: Hitec USA only services North/South America and Canada.
All other countries see appropriate distributor for service.
• If you are from a country that is outside North and South America, please contact the
Hitec distributor in your country for service.
Alan's Hobby, Model & RC FAQ Web Links
|Mar 28, 2012, 02:43 PM|
union township clermont county Ohio, United States
Joined Jan 2001
jshelton, Had a simular problem on an Optima 6. No signal on channel 1. Sent it to Hitec for repair. Turned out to be a cold solder joint on the channel I pins. George
|Mar 29, 2012, 05:51 AM|
Thanks Alan, George
I'm thinking you're right - that it's probably not a burnt-out channel but a damaged or defective connection. I'll see about sending it in to Hitec for repair.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Help! Burnt out Paraboard, WHAT HAPPENED. The fuse didn't burn out, the board was smoking||jasper7821||Batteries and Chargers||61||Apr 23, 2012 03:18 PM|
|Discussion Futaba 6J channel 6 = throttle as well as channel 3||jazznuts||Multirotor Talk||3||Mar 10, 2012 07:25 PM|
|Discussion Battery Telemlery in the Aurora 9 with Optima 6 receiver||Timewarp||Radios||8||Dec 26, 2011 07:08 PM|
|Sold Hitec Optima 6 and Optima 7 Receivers||daskip87||Aircraft - General - Radio Equipment (FS/W)||3||Oct 31, 2011 03:16 PM|
|Sold Hitec Aurora 9 with 9 channel Optima and 6 channel Optima reciever||stangman67||Aircraft - General - Radio Equipment (FS/W)||1||Feb 22, 2011 04:19 PM|