|May 25, 2012, 05:17 AM|
ET basic OSD, V3 or V4 altimeter?
I have the older basic OSD and will buy an altimeter for this to be used on my quad. However is the added resolution on the newer V4 worth it when using the basic OSD. In other words, can the basic OSD show altitude in decimals, ie 1.5m or is it only whole numbers (meter or feet)?
|Jun 02, 2012, 02:30 PM|
We haven't done much with the text OSD for the last few years. I can say for sure that the display will be in whole meters in metric mode. Unfortunately, I can't say for sure whether the Altimeter V4 is even supported with it. It would work in theory, but it has not been tested here.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||OSD Pro, eLogger V3, GPS V4 problems updating firmware in OSD Pro||jbfoamy||Eagle Tree Systems||23||Jun 02, 2012 03:59 PM|
|Help!||How to Connect ET basic OSD with barometric altimeter V4||motiganot||Eagle Tree Systems||1||Apr 20, 2012 07:43 AM|
|Discussion||Is the Spektrum TM1000 compatible with an ET Altimeter?||bmitchell138||Eagle Tree Systems||6||Apr 18, 2012 03:14 PM|
|Sold||ET OSD Pro, eLogger V3 and 10Hz GPS Expander Module (((Reduced)))||bah7566||Aircraft - General - Miscellaneous (FS/W)||1||Jan 25, 2012 01:25 PM|
|Sold||ET OSD Pro, eLogger V3 and 10Hz GPS Expander Module (((Reduced)))||bah7566||FPV Equipment (FS/W)||1||Jan 25, 2012 01:22 PM|