|Aug 06, 2011, 08:03 PM|
Pitts 12 15e construction underway!!!
My new Pitts 12 15e from e-Flite came in a few weeks ago, and I was awaiting the motor and a few additonal bits [sullivan wire kit, dubro tail wheel kit] to complete the build.
This will be initially a 3S, 3800mAh system with a 900Kv, 770W motor. I will be using a 60A ESC (Eflite) and 4x HS82MG servos (Hitec) for the controls. A AR500 full-range RX completes the ensemble. I have a TruTurn 2.25" aluminum spinner painted gloss back to match the scheme, and I plan to use a MAS 12x6x3-blade prop. (see pix)
Wings and Elevator were done about 10 days ago, and I am now finishing the build. First major mod is the battery tray lowering to accomodate larger batteries. I cut out the upper front spar and made one using 3/16" balsa. (see pix) It is the same hieght as the rear spar, to allow the tray to ride on both.
This will allow a longer new tray to fit into the plane and manage CG better.
I also used Weldbond white glue on the front inner wooden surfaces to strengthen them a bit without adding a lot of weight...
More pix to come as we continue the build!
ImagesView all Images in thread
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||E-Flite Pitts Model 12 15e Biplane||milehigh club||Aircraft - Electric - Airplanes (FS/W)||5||May 19, 2011 08:08 PM|
|Sold||1x E-Flite Pitts Model 12 15e ARF||Hoangsta||Aircraft - Electric - Airplanes (FS/W)||5||Nov 23, 2007 08:03 PM|
|Discussion||E-Flite Pitts Model 12 15e...||Safety Hawk||3D Flying||1||Aug 26, 2007 05:38 PM|
|New Product||E-flite Pitts Model 12 15e ARF||Bill K.||3D Flying||1||Aug 17, 2007 07:34 AM|