SMALL - SMALL - Telemetry SMALL - Radio
Thread Tools
Old Aug 21, 2014, 01:21 PM
Registered User
Joined Jun 2007
76 Posts

Hi I'm machining a Stuart D10 steam engine,my question is has any one temporally
glued the soleplate to the boxbed to facilitate the accuracy when drilling the two.
If you have what glue was used?
Thanks Bob
b willow is offline Find More Posts by b willow
Reply With Quote
Sign up now
to remove ads between posts
Old Aug 21, 2014, 08:30 PM
Registered User
Joined Jul 2004
85 Posts
Clean real well with acetone and glue with thin CA. Heat up to separate.
Tcat is offline Find More Posts by Tcat
Reply With Quote

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question A motor question and a Batt. connection Question WHTruce Multirotor Power Systems 0 Aug 19, 2014 05:33 PM
Help! Hangar9 B-25 engine mounting question--TWIN engine mounting question raron455 Fuel Warbirds 2 Aug 15, 2014 07:30 AM
Discussion Newbie to electrics..... questions, questions! LVsoaring Glow to Electric Conversions 29 Oct 15, 2013 03:56 PM
Discussion Airfield P-40 1400mm Retract & Servo Questions Tbolt65 Electric Warbirds 11 Sep 20, 2013 11:08 PM
Discussion I have a stupid newbie antenna question Hellysmack FPV Talk 9 Sep 20, 2013 05:21 AM