|Oct 20, 2003, 08:01 PM|
Best rudder servo for Magic 3d
Asking a question for a friend who flys a modeltech magic 3d with
4s4p TP 6100
He is in need of a faster rudder servo, digital or normal for better control in a hover.
I dont fly anything this big so I am not much help
I was maybe thinking of the Hitec digital micro or mino servos
|Oct 20, 2003, 09:09 PM|
The Hitec 225's are fine and a little smaller, standard Futaba servos are fast enough to control Magics in a hover with enough precision to hover rock steady. Sounds like he needs faster thumbs.
|Oct 21, 2003, 12:39 AM|
I would use a Futaba 3102. It's small, high torque and accurate. They've also been repriced from $60 to $30 at TowerHobbies. I've used the HS85 and 225. They are both very fast but a bit sloppy towards the center. Also, if you test about 4 225s, you'll find at least one that delays as it moves to center. It causes noticeable problems when you try to level out your plane.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|What is the Best AXI setup for 15oz 3D?||JohnnyDeluxe||3D Flying||77||Jul 31, 2009 06:15 PM|
|where should I install my rudder servo for SA Groove 480?||lagcisco||3D Flying||0||Apr 15, 2004 09:15 PM|
|Best tail servo for Hornet CP||jiri||Micro Helis||0||Nov 23, 2003 06:57 AM|
|Best micro servo for low voltage?||Tapio||Radios||4||Aug 28, 2002 08:04 AM|
|Metal gears required for all 4 servos for Magic 3d?||Balin||Sport Planes||3||Nov 14, 2001 11:49 AM|