|Jun 01, 2008, 12:08 PM|
Help finding upgrade/DIY project info please!!
Im from over in the scratch built airplane foamies forum.I have decided I want to get into electric boats too.It's a sickness Their is NO way Im going to pay $300 for one.I already have brushless motor's,lipo's,esc's and rx/tx gear laying around and am good with my hands so....I was reading THIS thread and it got me going.I might do this very upgrade project but is their more projects like this one out their?I've been skimming through the threads and so far Im suprised that there's not alot of info on different upgrade projects,scratch-built boats and DIY stuff.In fact,I think it would be cool if you guys started a upgrade projects,scratch-built boats and DIY stuff forum.
|Jun 01, 2008, 01:29 PM|
The Motor, Batteries you can use ok in a boat.. The ESC may only have forwards and not reverse, coming from a plane.. and the Tx / Rx is probably on 72mhz (Aircraft frequency) and not 75mhz (land / water based vehicles) so you may have to 'upgrade'.
A lot of people start with the RTR boats, but are unhappy with the performance and so upgrade to better motors, batts and RC equipment. Thats how a lot of boaters start out.. There are a lot of RTR conversions in these forums, its just a case of searching them out.
You will see most of the 'builds' on these threads (Dock talk and especially Scale boats) are scratch builds, where a lot of the running gear and fittings are scratch built... and some of the bits are made from things found around the house and garage.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Need help finding ni-MH battery info.||canadianufo||Batteries and Chargers||2||May 16, 2007 07:04 PM|
|Discussion||Help Sweet Vee Rocket Glider info please!||Roos||Rocketry||8||Apr 05, 2007 11:48 AM|
|can you guys help me with a little info please?||birdie_in_texas||Micro Helis||3||Feb 25, 2005 12:11 PM|
|Help finding Info on making canopies (lexan or other light material)||carlos2||The Builders Workshop||4||Feb 18, 2004 12:25 AM|