SMALL - SMALL - Telemetry SMALL - Radio
Thread Tools
Old Mar 17, 2012, 10:23 AM
Registered User
canso's Avatar
Canada, ON, Toronto
Joined Aug 2008
150 Posts
AR7000 rX problem


I have a brand new AR7000 RX that came with the DX7 TX. As I never had a use for it until now (no 7 channel airplanes in my fleet) I decided to hook it up and test it. I used the switch that came with it and bound it according to the instructions to the TX. The light blinks and then goes solid, stating it is bound. However, no servos seem to work. I tested a AR6000 RX to see if I was delusional, but that RX works fine. Now a friend of mine has the exact same AR7000 RX and the same thing happens.

IS this just a bad RX or is there something else needs to be done? Such as update firmware etc.
canso is offline Find More Posts by canso
Reply With Quote
Sign up now
to remove ads between posts
Old Mar 17, 2012, 11:17 AM
AndyKunz's Avatar
Joined Sep 2001
27,616 Posts
The AR7000 needs its remote receiver attached (you will have to bind again).

As a safety feature, the receiver does not give control to the servos unless it's receiving signal from both internal and external receivers.

AndyKunz is online now Find More Posts by AndyKunz
Site Sponsor
Reply With Quote

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold 2 AR7000 RX's for sale ryan_m Aircraft - General - Radio Equipment (FS/W) 3 Feb 24, 2012 01:56 AM
Sold AR7000 Rx with Remote Rx. rudyy Aircraft - General - Radio Equipment (FS/W) 1 Jan 23, 2012 06:39 AM
Sold Spektrum DSM2 AR7000 RX with Satelite RX crosby Aircraft - General - Radio Equipment (FS/W) 6 Nov 11, 2011 01:52 PM
Discussion AR7000 RX Ni-Cd 4.8v 700mah problem... LaurenceGough Radios 9 Dec 18, 2007 01:24 PM
Discussion AR7000 RX Ni-Cd 4.8v 700mah problem... LaurenceGough Batteries and Chargers 5 Dec 18, 2007 12:19 PM