|Feb 13, 2013, 10:37 PM|
hey everyone im have a issue with my trimming for my heli. this is what i have, Dynam Erazor 450, 6ch, 3D ,brushless ,All metal. the tx/rx im using is the factory Dynam 6ch transmitter and receiver. the problem im having is no matter how much i try to trim the tail rotor it still seems to drift left or right. i found center on the trim bar but i cant completely center it. 1 click to the right and the tail rotor drifts slowly left and 1 click to the left and the tail drifts slowly to the right. (Looking at the tail rotor) i cant seem to find center. my other trims seem to be fine or maybe my heli needs adjusting. can any one help me with this issue?
|Feb 20, 2013, 08:12 AM|
|Feb 20, 2013, 09:13 PM|
If your gyro is in HH mode the tail should not drift at all, only if your gyro gain is set to low (or you got a crappy gyro)
Is your gyro set to HH or rate mode?
If you want to trim your tail you have to be in rate mode and DON'T use the radio trim - only mechanical !
If you are not planning on flying in rate mode your trim don't has to be 100%, just switch to head hold and adjust your gain. I think only scale pilots still fly in rate mode.
What gyro are you using anyway?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||HobbyZone Super Cub Fail-safe trim setting problem||aeronaut999||Foamies (Kits)||6||Jan 15, 2013 07:54 PM|
|Discussion||Twister Aggressor2.4 Problem - Constant rudder trim & trim direction change needed?||shmike||Coaxial Helicopters||0||Apr 02, 2009 12:41 PM|
|COG problem or Trim problem?||Newberry||Beginner Training Area (Aircraft-Electric)||31||Aug 19, 2003 12:47 PM|
|SB Trim Problem||Tim K||Parkflyers||20||Jun 07, 2002 11:58 AM|
|Futaba 8U - Problems With Digital Trims||DaveSawers||Electric Plane Talk||5||Oct 26, 2001 07:24 PM|