|Jan 17, 2014, 02:30 PM|
Joined Mar 2013
range Video Question ?
Can someone please help me by showing me a Picture or describe how i should add a Bex to the RVOSD so that there is power in my esc and servo's ? as now i dont have any power going to my RC/RX ?
I thout that the Esc was there for that perpess ? And if I add a Bec, do i then have to remove the power line from my ESC going to the OSD ?
I apprishiate any help, specially a Picture, that makes it much easier to understand..
|Jan 17, 2014, 02:44 PM|
Joined Oct 2012
hard to get a picture, as its all buried in the plane... but...
but in a nutshell, yes, you remove the power line in the ESC servo wire. pull the pin out, cut it, whatever you prefer, when you run a stand alone bec, the power cable from the esc needs to be eliminated.
If you have a spare slot on the OSD, you can plug the BEC into that (no signal pin of course, it wont have one).
If you dont have a spare slot, you need to get a Y 1 to the BEC, 1 to the ESC (with the power pin removed)
The net result going to the OSD is ESC and BEC ground, ESC Signal, BEC Positive.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||RVGS, Range Video Ground Station||acky||FPV Equipment (FS/W)||1||Nov 25, 2013 09:11 AM|
|Sold||Range Video OSD 5 - RVOSD!||boehmr||FPV Equipment (FS/W)||4||Nov 24, 2013 02:56 AM|
|For Sale||RVOSD Range Video OSD||andy@laundryco||FPV Equipment (FS/W)||1||Nov 09, 2013 01:14 PM|
|Sold||Fat Shark teleported V3 and Range Video 1.3GHZ TX||sushiman1841||FPV Equipment (FS/W)||2||Nov 06, 2013 08:49 AM|
|Question||Some questions about wireless video...(Range Video system and flying by video)||Picoflyer||Aerial Photography||22||Nov 21, 2006 04:54 PM|