|Jan 31, 2013, 03:40 PM|
KK2 battery voltage question
I know this must have been asked here, searched but cannot find an answer.
I'm using a kk2 fc in my y3 tricopter build and on the kk screen it says bat voltage 0.0v how do u use this function? I have a separate voltage monitor but thought if the kk inbuilt one works ok it will save some extra wiring as I'm also running leds from the battery balance connector. I have read that it only shows total voltage, the kk pdf manual does not seem to mention it.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||KK2.0-12a ESC-hextronic 1300kv motors..question||thefatlebowski||Multirotor Electronics||5||Jan 29, 2013 11:31 PM|
|Discussion||estimating battery voltage while flying||abuzer01||Batteries and Chargers||3||Jan 11, 2013 05:28 PM|
|Question||Lithium battery voltage question||stevenham||Batteries and Chargers||2||Jan 08, 2013 02:37 AM|
|Question||Lipo voltage curve question||fly2bob||Batteries and Chargers||5||Jan 05, 2013 12:49 PM|
|Discussion||Quanum battery voltage telemetry - and 'voltage under load' question ...||JJJNYC||Batteries and Chargers||40||Dec 15, 2010 08:45 PM|