|Jul 21, 2014, 08:32 AM|
Need help: Strong Run EVO settings
I bought Laqua Strong Run EVO from some dealer in Japan. I wish to fly this airplane as a sloper.
The instruction sheet which comes with the kit only says that the CG should be 47mm to 57mm from the leading edge. I would be grateful if anyone kindly let me know the followings:
1) the aileron/ elevator control throw
2) the crow setting for aileron and elevator
3) any tips for building or flying this airplane
Thanks in advance,
|Jul 21, 2014, 09:26 AM|
Nice plank!And a good size.Try posting on the slope forum,the guys there will help.
Include this link-
Have you looked on the German forums quite a lot of info there.
|Jul 21, 2014, 09:49 AM|
Thank you for your reply.
I wish to post the slope forum.
BTW, I already checked the thread 'Strong Run EVO - Fragen und Tips' @ RC-Network.de.
No setup info is there
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Need help to set up a Tri-copter and V-tail copter.||lrplin||Multirotor Electronics||4||Nov 15, 2013 04:48 PM|
|Discussion||Need help to set up the sheets in scratchbild.||Mats W||Sailboats||4||Nov 06, 2013 02:05 PM|
|Help!||Help needed to change settings of HD camera.||mykalt45||Aerial Photography||1||Oct 11, 2013 04:10 PM|
|Discussion||Here's a new one, need help getting an EVO to STOP running.||Wookster||Engines||19||Oct 09, 2012 12:34 AM|
|Wanted||Wanted! I need a strong running 1/8th scale motor||Ready2Fight||Cars - Trucks and Parts (FS/W)||6||Feb 15, 2011 10:52 PM|