|Aug 21, 2014, 04:12 AM|
E-Flite Slick 3D 480 ARF
gee a lot of 3d stuff this year but yet again this looks very nice
Ultra-lightweight, laser-cut balsa and plywood construction
Two-piece, plug-in wings with carbon fiber joiner tube
Ready-to-mount the recommended E-flite® Park 480 outrunner
Large spring-latch canopy hatch provides ample access to battery and electronics
Fiberglass control horns and threaded pushrods with ball-link hardware
Large control surfaces with double-beveled hinge lines for all-out 3D performance
Vibrant trim scheme in genuine Hangar 9® UltraCote® covering
Pre-painted fiberglass cowling and wheel pants
Durable aluminum landing gear with painted finish
Steerable tailwheel and quality hardware package
Needed To Complete
4+ Channel transmitter and receiver radio system
Brushless outrunner motor
Brushless speed control
Flight battery pack
Assembly Time: 5-7 Hours
CG (Center of Gravity): 75-82mm behind leading edge at wing root
Experience Level: Intermediate
Flying Weight: 37.5-39.7 oz (1125-1063 g)
Fuel Type: Electric
Is Assembly Required: Yes
Motor Size: Park 480 BL Outrunner
Overall Length: 39.5 in (1000mm)
Plane Type: Aerobatic & 3D
Power Plant Size: 450-480 Electric
Prop Size: 12x6 electric
Radio: 4+ Channels (Required)
Recommended Battery: 11.1V 3S 1800-2200mAH LiPo
Recommended Environment: Outdoor
Servos: 4 Sub-Micro (Required)
Speed Control: 40-Amp Brushless (Required)
Spinner Size: 2 inch
Trim Scheme Colors: Bright Yellow, Silver, True Red, Deep Red, Transparent Clear
Wing Area: 390 sq. in. (25.1 sq. dm.)
Wing Tube Length: 15.35 in (390mm)
Wing Tube OD: 0.51 in (13mm)
Wingspan: 42.1 in (1070mm)
|Aug 21, 2014, 06:08 AM|
Joined Jun 2014
Love the short moment arm on this thing, makes a plane more agile and often more robust.
If it is about the same price as the Extra 260, this is a must have for me.
Look forward to seeing demo video.
|Aug 21, 2014, 09:55 AM|
Like the look of this one,But i have enough 3D planes for now,would be intrested though to see others view on this and what they think of it.
I would like to find out the price for the airframe actually if any of you have any idea let me know,It would be also intresting to price the speccing out parts to see the total cost,If it was reasonable then count me in,would have to check price though first.
|Aug 21, 2014, 11:57 AM|
Joined Jun 2014
That opening maneuver, the flat inverted tight spin proves my point about the short moment arm. That's the first E-Flight video i have seen with clean rollers (fuselage not wangling), i don't know if that's because of the new plane or a new Pilot?
Surprised they never showed KE, i think it's going to be a stunner at this with it's chunky and short fus (gives the fus a rearward cg - when in KE).
Hope to beat Dan at a video of this
|Aug 21, 2014, 11:59 AM|
Sorry for a double post,Firstly the video looks great,plane looks beautiful,but something that strikes me as odd is the reccomended power system for a balsa plane of this size is 3cell power 1800-2200mah size pack!?
Just got this plane and it is so light that a 3cell is loads of power!
Wrong observation on my part.
|Aug 21, 2014, 04:45 PM|
I think it's powered perfect. It's aimed directly at the 42" Slick from 3D HobbyShop which suggest a 3s of similar size. I've had the 3DHS Slick and it's a great plane and has been one of if not their best seller for the past few years. I just wonder who would rather pick this up over theirs that has a massive following and has a reputation for being incredibly tough. At fun flys they challenge people to try to break it (in the air).
|Aug 21, 2014, 04:49 PM|
Surprised they never showed KE.... QUOTE]
1:25 of the video the pilot does a nice low knife edge pass. Not high alpha but it still looked nice.
|Aug 21, 2014, 04:55 PM|
Well on the parkzone visionaire on 3cell i had my timer set at 5mins flight times flying hard 3D,was many times that i ran out of juice just over the 4minute mark,lipos can be tempremental as we all know,and had to pretty much dead stick it in,would be intrested to hear the flight times on this,I would be doing anything balistic in the first 2 minutes and general flight after that.
To be very honest the Visionaire was a foam plane and it wasn't the most powerful to pull out of a hover,this plane has the same running gear,again not cutting it just been realistic,I could be wrong in my observations,the plane could be lighter than the visionaire! lol
In a nutshell,just my opinion of course,I love the look of it,but i would have to see/read some user reviews on it before
pulling out the wallet.
|Aug 21, 2014, 04:58 PM|
United States, IL, Glenwood
Joined Nov 2013
I would put a power 10 in it instead of the park 480. Then put a 2500 4 cell in it and see if I could rip the wings off of it.
|Aug 21, 2014, 05:02 PM|
Would love to see you flying it,no i would have to wait now to hear some reviews on this one,sorry for any negativity but i couldn't risk it given the tempremental flight times i used have on 3cell 3D flights with airframes this size.
I suppose there is nothing stopping one from using a light 4cell set up.... would that make it a little heavy??
|Aug 21, 2014, 05:36 PM|
Pre-Order at $149.99 plus shipping!
|Aug 21, 2014, 05:38 PM|
The Visionaire weighs about 10oz more than the 3dhs and e-flight slicks
I would say watch some of the many vids on YouTube in the 3DHS and see if you like the 3s setup. Many have done 4s and some have even gone 5s. On 3s mine had plenty of power to pull out.
I do like the looks if the E-flite Slick better than the AJ though.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Twist 3D 480 ARF by E-flite||simages||Aircraft - Electric - Airplanes (FS/W)||0||Apr 05, 2014 08:30 PM|
|For Sale||Edge 540 BP 3D ARF by E-flite||oagh||Aircraft - Electric - Airplanes (FS/W)||0||Oct 29, 2013 10:12 AM|
|Sold||E-flite Park 480 / E-flite 30A ESC / Props||dblades||Aircraft - Electric - Power Systems (FS/W)||2||Oct 21, 2013 12:08 PM|
|New Product||E-Flite Extra 260 3D 480 ARF||thomer||3D Flying||203||Apr 11, 2009 11:12 PM|
|For Sale||E-Flite Extra 260 3D 480 ARF w/ Park 480 1020kv||moxjett||Aircraft - Electric - Airplanes (FS/W)||8||Jan 17, 2009 07:46 PM|