Joined Jul 2015
BE1806 wobble naza robocat
so built a robocat (have a venture)
be1806 2300 motors
hobbyfan 12a bec esc (+ removed)
5045 and 5045 triple blade
everything is brand new, havent "flown" only tested. 1 motor (replacement being sent) I thought was the issue. It "stops" spinning and seems to be giving a bit of vibration.
props off it doesnt look like it has a bent shaft or anything.
I tried testing each motor with prop then in pairs, then in 3's and then in 4's to deduce which motor is the actual problem, but when taking off I have a wobble. Holding in my hand, I also experience the wobble around half stick but if I go to full throttle, the wobble disappears.
some have suggested bent shaft, unbalanced props. but wouldnt the wobbling get worse with more throttle?
any help from veterans would be appreciated, this is my first build after flying venture (which I love!)
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Naza death wobble ny help me||Suffolk_speed||Multirotor Electronics||7||Jul 15, 2015 02:48 PM|
|Discussion||Naza V2 bad Yaw Wobble on Black Snapper foldable Quadcopter - SOLVED!!!!||schim||Multirotor Electronics||1||Aug 26, 2014 03:41 AM|
|Help!||Tarot FY690s Hex Naza-M "Wobble"||smarks||Multirotor Talk||3||Aug 26, 2013 11:15 AM|
|Help!||TBS Discovery / Naza Annoying Wobble!||Jmm_jammy||Multirotor Talk||12||Aug 26, 2013 01:38 AM|
|Discussion||Wobbly flying with Naza , a gain to low or to high?||WonderKing||Multirotor Electronics||5||Jul 11, 2013 09:32 AM|