HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Jan 31, 2013, 04:40 PM
Registered User
ripmax's Avatar
uk. northampton
Joined May 2009
1,006 Posts
Discussion
KK2 battery voltage question

I know this must have been asked here, searched but cannot find an answer.

I'm using a kk2 fc in my y3 tricopter build and on the kk screen it says bat voltage 0.0v how do u use this function? I have a separate voltage monitor but thought if the kk inbuilt one works ok it will save some extra wiring as I'm also running leds from the battery balance connector. I have read that it only shows total voltage, the kk pdf manual does not seem to mention it.

Thanks anyone!
ripmax is offline Find More Posts by ripmax
Reply With Quote
Sign up now
to remove ads between posts
Old Jan 31, 2013, 05:15 PM
Manual will not flyaway :D
ecks's Avatar
Sweden, Gothenburg
Joined Oct 2012
3,139 Posts
Just connect a wire from



To a positive on the battery or power distribution. There is a small hole on the kk2 to feed the wire into
ecks is offline Find More Posts by ecks
RCG Plus Member
Old Feb 01, 2013, 05:38 AM
Registered User
ripmax's Avatar
uk. northampton
Joined May 2009
1,006 Posts
Thanks
ripmax is offline Find More Posts by ripmax
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Quanum battery voltage telemetry - and 'voltage under load' question ... JJJNYC Batteries and Chargers 51 Oct 22, 2014 12:55 PM
Discussion KK2.0-12a ESC-hextronic 1300kv motors..question thefatlebowski Multirotor Electronics 5 Jan 30, 2013 12:31 AM
Discussion estimating battery voltage while flying abuzer01 Batteries and Chargers 3 Jan 11, 2013 06:28 PM
Question Lithium battery voltage question stevenham Batteries and Chargers 2 Jan 08, 2013 03:37 AM
Question Lipo voltage curve question fly2bob Batteries and Chargers 5 Jan 05, 2013 01:49 PM