|Aug 13, 2012, 03:40 PM|
KK2 Board Throttle On Plug In
So I have this KK2 board that just brings to motors to, i'm guessing 60% throttle when I plug the LiPo in. I have checked my trims on my TX and set the minimum throttle to 0 on the KK2. I have also confirmed that 0 throttle does register as 0 in the settings. The manual doesn't seem to say anything about it. ESC calibration seems to allow a max throttle of 70% and a minimum of 50%. Bad board?
Further, it looks like it killed one of my ESCs...
|Aug 13, 2012, 04:48 PM|
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Wanted||Mpi on-board electronic glow plug driver||HAWKEYE44444||Aircraft - Fuel - Engines and Accessories (FS/W)||2||May 17, 2012 09:33 PM|
|Help!||Anybody work with a Sullivan On-Board Glow Plug Driver?||jodini||Engines||1||Mar 26, 2008 05:50 PM|
|Question||Motor doesn't run til half throttle on tx and what's this plug?||expo||Power Systems||14||Jan 04, 2008 10:57 PM|
|On board glow plug switch?||Fishmasterdan||DIY Electronics||15||Jun 30, 2005 10:39 PM|
|any advice on how to keep your esc reiceiver plug soldered up good to the p.c. board?||airborn express||Power Systems||5||Oct 08, 2003 04:59 PM|