|Jul 15, 2013, 07:17 PM|
Above and below tails
Usually the bottom of a vertical stabilizer starts in the fuselage and extends upward. Mostly seen on DLGs, vertical stabilizers are equally 50% above and 50% below the fuselage so as to minimize the boom twist leverage generated when discus launched.
Here is an example of an “above and below” vertical stabilizer on a larger (actually 208”) sailplane which is this years AMA Nats XC winner “Frankenstein” by Peter Baumeler. What a beautiful sailplane.
Are there any aerodynamic disadvantages to an “above and below” vertical stabilizer?
Last edited by FlyVA; Jul 18, 2013 at 03:51 PM.
|Jul 15, 2013, 07:41 PM|
With the very slender tailboom on this model, I can see the need to reduce torsional loads, hence the "balanced" vertical stabilizer.
As to aerodynamic advantages, a larger AR becomes possible but the fin/rudder is usually generating little lift compared to a wing (lifting surface) so I doubt a high aspect fin would make much difference.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Stab Above Or Below The Boom?||steelhead||Hand Launch||22||Jul 25, 2008 12:52 AM|
|Discussion Slow Stick motor. Above or below?!||twoshadetod||Electric Plane Talk||7||Jan 27, 2008 08:02 PM|
|Discussion No hell below us, above us only sky.||Michael in Toronto||Life, The Universe, and Politics||10||Dec 08, 2006 10:24 AM|
|Discussion Gearbox/outrunner: above or below fuse?||geekdom||Beginner Training Area (Aircraft-Electric)||2||Jan 18, 2006 12:06 PM|
|Coast Guard c-130 pictures from above and below needed.||Michael Heer||GWS (Grand Wing Servo)||2||Nov 07, 2004 07:21 PM|