HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Apr 17, 2014, 04:55 PM
Registered User
Joined Sep 2013
3 Posts
Discussion
Servo ideas

Hi, I have a small project where I would like to control the pan and tilt of a camera. Basically I would want the camera to rotate at every 60 degrees, 6 times then the camera would tilt to new angle and then rotate again 6 times every 60 degrees and finally tilt again and stop.

So far I have seen that this is pretty much all possible using the Pololu Maestro Servo Controller and software to program it.

http://www.pololu.com/product/1352

The main problem I have is finding the right servo that I can use to move at 60 degree intervals through a full 360 degrees. It seems that some servos only do 180 deg. I am pretty new to all this stuff and trying to avoid costlt mistakes.

Any help appreciated.
nerjavirtualtour is offline Find More Posts by nerjavirtualtour
Reply With Quote
Sign up now
to remove ads between posts
Old Apr 17, 2014, 09:46 PM
Registered User
Joined Aug 2013
577 Posts
Do some research on gimbal motors. They are designed from the ground up to position cameras. They may be more expensive than servos, but they will get the job done very easily, I believe. I have no firsthand experience with them.
Mike Dubovsky is offline Find More Posts by Mike Dubovsky
Reply With Quote
Old Apr 18, 2014, 02:25 PM
homo ludens modellisticus
Ron van Sommeren's Avatar
near Nijmegen, Netherlands
Joined Feb 2001
10,432 Posts
->search the DIY electronics subforum!
Ron van Sommeren is offline Find More Posts by Ron van Sommeren
Reply With Quote
Old Apr 18, 2014, 02:35 PM
An itch?. Scratch build.
eflightray's Avatar
South Wales U.K.
Joined Mar 2003
12,791 Posts
Also see if any of these mechanisms would help --

Hobby King Camera Gimbals

also

Hobby King Gimbal Controllers

and

Hobby King Pan and Tilt Units
eflightray is offline Find More Posts by eflightray
Reply With Quote
Old Apr 18, 2014, 03:18 PM
Registered User
Morristown,NJ
Joined Oct 2003
161 Posts
sail winch servo:
http://www.hobbyking.com/hobbyking/s...40kg_150g.html
moyg is offline Find More Posts by moyg
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Elevator to flap mixing: dumb idea or good idea??? (see video) rudyauction509 Electric Plane Talk 20 Nov 16, 2013 07:24 PM
Wanted Receiver, Servos setup? Will entertain offers/Ideas! Tommy D Aircraft - Electric - Airplanes (FS/W) 1 Apr 21, 2004 10:22 PM
Need some ideas about servos AUBrian Hand Launch 3 Sep 24, 2002 12:22 AM