|Oct 20, 2012, 09:50 PM|
United States, CA, Lancaster
Joined Dec 2011
I am fairly new to this hobby and have been flying a t Rex 450 clone and want to add a fly mentor. It came with a flysky tx that I understand how to program,but I bought a spectrum dx6i and orange dsm2 rx to use with the fly mentor. I had no trouble binding but cannot get the servos to work correctly. I have tried reversing with no luck. The throttle lifts all servos up but they don't move correctly for elevator or aileron. I have a few simple questions that are probably stupid but I'm stuck. I don't understand why there are not two aileron ports on the rx isn't there two servos that control side movement. Also what is the gear and aux 1 port for. Hope someone can help me thank you
|Oct 20, 2012, 11:21 PM|
United States, TX, Fort Worth
Joined Jan 2009
Gear is for remote gyro gain if equipped.
Aux 1 is for that "other" AIL servo.
ELE channel is always the standalone servo, front or rear.
If all servos perform PIT properly, it may only be a matter of swapping AIL and AUX wires on the receiver. If that doesn't work, invert AIL in the SWASH MIX menu.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Spektrum DX6i Help||Tanis1010||Radios||6||May 02, 2012 05:56 AM|
|Discussion||Need help setting up stryker with dx6i.||John S.||Electric Plane Talk||2||Mar 28, 2012 03:35 AM|
|Discussion||Need help setting up stryker with dx6i.||John S.||Beginner Training Area (Aircraft-Electric)||6||Mar 27, 2012 07:12 PM|
|Discussion||Need help setting a LP5dsm up to buddy box W/dx6i||pops57||DIY Electronics||1||Mar 16, 2012 04:33 PM|
|Discussion||Dx6i problems with gear...help!!!||moparkris||Radios||2||Mar 02, 2012 06:41 AM|