United States, AZ, Surprise
Joined Jul 2002
Am having troubles using the "trim after cutting"......
Everything is fine cutting with "no trimming", "trim only" but
when using "trim after cutting" it goes "willy-nilly". The trim cuts are
way out of where they should be. Also the cuts are way out
of where they should be. It's like it forgets where the sweep is.
Has anyone seen this???
It's been a while since I've cut anything, I get "melted foam" when
cutting. Especially around L.E.. Can't remember if I add heat or slow
down.By the way I'm using ver 3.89.15.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||GMFC with Profili and CAD Advice||ALEX HEWSON||CAD/CAM||2||Jun 13, 2012 05:22 AM|
|Discussion||GMFC Problem with Windows 7||cpc625||Hand Launch||0||Apr 04, 2011 11:08 PM|
|Discussion||CNC Foam Cutting problem with GMFC||wimmeke||CAD/CAM||0||Jan 14, 2010 01:24 PM|
|Help!||"GMFC" PROBLEMS CUTTING TAPERED WING||Dale W||The Builders Workshop||3||Jul 22, 2007 02:56 AM|
|Discussion||GMFC problem on tapered wing||skankpile||The Builders Workshop||7||Aug 20, 2006 06:35 AM|