Programming Hitec center
Okay, now that I have the software running fine. I have a "how to" question.
How do I set the center position if that center position does not correspond to 1500 usec?
I am using the HS-5065MG servos on the swash of my Rave helicopter. The goal here is to have the servo arm in a specific position (in this case perfectly parallel to the body of the servo) when the collective control is at 50% with no cyclic input.
The problem is that my radio does not put out a 1500 usec pulse width when in this position. I have double checked all settings. The sub trims are zeroed, the trims are all zeroed in all flight modes and the end point adjustments are all set to 100%.
What I am seeing coming out of the radio is about 1528 usec from the receiver on one of the swash channels. I don't recall what the others are but they are similar, but not identical.
This means that I can set the perfect center position and hit the button on the software that sets center at that position. But that only sets the position for 1500 usec. When I connect the servo to my radio and set the controls where needed, the servo is off just a little bit.
Is it possible to set a specific position for a specific pulse width?