You missed it Mitch.

Wayne your box is full

Originally Posted by mudlark

Wayne your box is full

Emptied

10% off gopro 3 black at Chainreactioncycles .......hmmm tempting
Anyone seen them cheaper?

Good deal but mine only cost me £250.
Should of got a few more.

Oh
Best Buy
Silverdale
Washington

I dont know Mitch but sorry chap.

looking forward to the weekend now, new KK board to play with and I hope it gets my interest going on the tricopter again.

and I have a slight confession to make......just checked the channels on my VTx and VTr and they where on completed different channels, I'm amazed I got any signal at all.
All I have to do is ground range test it and I hope I should get my first bit of true FPV flying in this weekend.

Originally Posted by blackbrabus

...just checked the channels on my VTx and VTr and they where on completed different channels, I'm amazed I got any signal at all..

Know the feeling been there before...haha specially on the 200mw Boscam style vtx, sometimes the switch direction on the manual can be opposite what it shows on the vtx (trust me ive had that issue before!)

Dammit....free shipping is now a million miles away...

Originally Posted by DodgeRC

Know the feeling been there before...haha specially on the 200mw Boscam style vtx, sometimes the switch direction on the manual can be opposite what it shows on the vtx (trust me ive had that issue before!)

What I cant figure is why I got a video signal at all running different channels.

Originally Posted by blackbrabus

What I cant figure is why I got a video signal at all running different channels.

If you were on a different channel, but say slightly out, you should still get some signal I think? Although image is normally terrible.

Last time I had the issue where it was only getting 50m out then no signal was when I had 2 female connectors (SMA-SMA?)

Has anyone tried connecting a Dragonlink 2 tx to a Turnigy X9 which hasn't had the firmware flashed? I am getting a red flashing light indicating no PPM signal, I have checked the settings on the X9 are set to PPM and double checked that CJ had labelled all the pins correctly, which of course he had.

Originally Posted by JaeDubbya

Has anyone tried connecting a Dragonlink 2 tx to a Turnigy X9 which hasn't had the firmware flashed? I am getting a red flashing light indicating no PPM signal, I have checked the settings on the X9 are set to PPM and double checked that CJ had labelled all the pins correctly, which of course he had.

yep both me and Mike the Crash have them working fine.
Trying to remember (too much info running round in my head these days) but it might be some thing to do with the ...

pause...

getting my tx....

Mine is set to 8CH 300uSec
PPM FrLen 22.5mSec

I hope this helps

FYI guys
Been looking at trying to get the best micro sd card card for the GP3B
I have the recommended sd card Sandisk 16g
Tonight I cane across a little test program called H2testw
I tested the card basically write 1g files and varifies.
I got some good speed results see screen capture.
Now to test an 8g class 2 see what results for that one is

here is the result for a sandisk 8g SD class 2 card