|Mar 14, 2012, 04:03 PM|
Turnigy 9X (now ER9X) and nav lights not going off
I have a Turnigy 9x (ER9X) and have wired an E-Flite light controller LED system into my quad which works great except one small detail.
When the switch is on (THR) my lights are nice and bright. With the switch off the lights go dim, not off. Any idea on how to get them to go off when the switch is off?
I tried playing with the EPA but not sure what else to try.
|Mar 15, 2012, 08:04 AM|
To dim an LED you have to pulse it rapidly, simply lowering the voltage won't make them dim the way a filament bulb does, so it sounds like it has something to do with the channel's characteristics. You mentioned the switch you're using as "(THR)", if you have it plugged into the throttle channel that might explain it. That's how the ESC slows a brushless motor, by pulsing it slower. Try connecting the lights to another channel, like the gear (5) channel.
|Mar 15, 2012, 10:22 AM|
Its an eflite light controller. I have it on the thr switch. Pulsing low makes sense. Ill try moving it and see what happens. Thanks!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||SETUP Turnigy 9x with ER9X setup for NAZA?||Medicineman76||Radios||0||Feb 26, 2012 08:51 PM|
|Sold||Turnigy 9X with ER9X and battery. NEW!||JIMinKENTUCKY||Aircraft - General - Radio Equipment (FS/W)||5||Feb 23, 2012 04:30 PM|
|Sold||Turnigy 9X Version 2 board with ER9X and battery. NEW!||JIMinKENTUCKY||Aircraft - General - Radio Equipment (FS/W)||6||Feb 22, 2012 11:03 PM|
|Discussion||Turnigy 9x + Frsky + er9x||JasonR54||Radios||3||Jul 04, 2011 11:16 PM|
|Help!||How can use switch Turnigy 9X(FW. ER9x) in Simulator||NiceOh||Simulators||3||May 21, 2011 10:51 AM|